Thanks wiedehopf I will use the Rpi
Can tar1090 run on Radarcape? I did the ADS-B Exchange Setup Scripts install and my feeder is online but can't access any tar1090, I did use the...
Thank you for all the help wiedehopf and foxhunter
Here is the output https://pastebin.com/ZnjRimHp the myip is showing Feeder connection. MLAT connection. Thanks
Yes I'm running the commands on the Radarcape here are the 2 two Pastebin links Pastebin 1 https://pastebin.com/wEjRE2Rv Pastebin 2...
yes I did reboot here is output Unit adsbexchange-feed.service could not be found. Thanks
Thank you wiedehopf and foxhunter for all the help I did check and I'm not using VPN, I have tried the sudo journalctl -u adsbexchange-feed |...
Thanks wiedehopf I was able to install but when I go to https://www.adsbexchange.com/myip/ I still get this No beast data detected from No...
Thank you for the help I did commends but getting No beast data detected or No MLAT data detected I also did the cat /etc/default/adsbexchange...
Thanks, Foxhunter and wiedehopf for the help did the sudo apt update and sudo apt install -y curl but when I tried the curl -L -o /tmp/axfeed.sh...
Thank you for the help not too familiar with Linux is it sudo apt update then curl -L -o /tmp/axfeed.sh...
I'm tiring to install the ADS-B Exchange Setup Scripts on Radarcape so I can send MLAT I followed the steps listed at...
Hi, looking at buying ADS-B Exchange Pre-Assembled 1090/978 Feeder Kit for the new site and have a few questions...
Separate names with a comma.
