OK...I'll just let it run and check back in a little while and see if I'm on the feeder pages at all. I'm not in the UK.....I'm in USA(Michigan)....
[email protected]:~ $ sudo service mlat-client status ● mlat-client.service - LSB: Multilateration client Loaded: loaded (/etc/init.d/mlat-client;...
can you dumb that down for me just a bit and how I can correct it? I'm looking at some of the feeder sites and now seeing an icon pop up for me so...
Well silly me....I was actually putting my IP address at the end there....LOL lines out output: 13 Data incoming from: 68.37.208.138 Route:...
Hi again all! Just ran the update from the beginning of this thread and everything worked as written. The only issue I'm having right now is the...
Only thing I can see being an issue right now is the antenna.....but nothing is wrong with the antenna and the feedline is 100' of LMR 400 flex...
https://ibb.co/hH9GRSg Hi again guys, the link above shows you my dump map which right now has 13 aircraft listed but concentrated to my home...
OK...here are the results of the second round of testing.....something definately not right only seeing 3-4 aircraft.... [email protected]:~ $ sudo...
Right now yes, just 3 aircraft.
I need to make a correction here......I took the discone out of line a couple weeks ago and put in it's place my Comet GP series 2/440/6m ground...
All 5 test done, all with same results: gain=49.6-20.7 messages=3 positions=0 planes=0 ===Totals=== Gain, Messages, Positions, Aircraft 49.6 15...
Yup.....and thanks again for being patient with me I know noobs drive people crazy but you guys are really teaching me and I appreciate the time...
OK....that seemed to work a lot better.....it now says Test 1 0f 5 so I'm assuming it's working, I'll give it some time...
[email protected]:~ $ sudo ./optimize-gain-mut.py test 1 of 5 Traceback (most recent call last): File "./optimize-gain-mut.py", line 18, in <module>...
I'm only having one issue with this. The script is pretty straight forward but how do I get the script? I cannot copy and paste because I flashed...
Separate names with a comma.