Alas, it worked fine for about 15 mins and has now stopped again. Attached is what I get with sudo journalctl --no-pager -u adsbexchange-stats Thanks
Many thanks, that's resolved the problem Much appreciated
Here it is... Thanks
I've been feeding data to ADSBx for some time without problem, and also had the Stats program running without a problem.. However, over the last...
adsbexchange-stats was working fine for two days and has suddenly stopped. I've no idea why. The feed seems to be still working. Any suggestions...
Is it permissible to have more than one feeder from the same IP address?....different receiver setup and antenna in a slightly different location...
Thanks. I've upgraded from Stretch to Buster and reinstalled everything and the 'stats' are now working fine.
This is all I get when I check the status [ATTACH]
Thanks. Yes it is running (active). I've tried restarting it a few times but still not stats links at https://adsbexchange.com/myip/ Also I don't...
Thanks for the suggestion but still no joy, just the page as described above
I don't get any links from that page other than to the adsbexchange-stats script page. I get my IP address and two smiley faces for feeder...
I've installed adsbexchange-stats on my Pi and have checked the status and it seems to be running, however, when I go to:...
I've checked all the script files and they were fine. Done a reboot and part 51358 is showing my data again. Should I submit another claim form...
I had a short Broadband problems yesterday so the Pi lost connection for about 5-10mins
Yes, all seems to be working fine locally
This is all getting very frustrating. I was feeding to port 51358 as suggested by an Administrator. I submitted a form on Sunday (20th October) to...
Although I was told 24hrs ago that my Rpi setup was fine, I'm still not showing in the Mlat Feeder Stats, and there is no feed of data to my VRS....
That's the script I have. VRS does connect but there are no messages. I'll leave you in peace now as i've taken up a lot of your time and will...
This is the VRS setup which is identical to what you suggested. Also is my modified MLAT scipt correct? [ATTACH] [ATTACH] [ATTACH] [ATTACH]
I've tried this but don't see any traffic. Do I use the IP of the Pi in the address or 127.0.0.1? Also do I need to tick push receiver?
Separate names with a comma.
