Hello guys. An info. I installed Dump1090 FA on my Raspberry PI3 with a FlightAware stick and antenna on roof From the terminal I receive all flights over my house well, those with ADS-BP Planes with MALT and others (TIS-B - ADS-C) no I read ICAO but the coordinates don't arrive and I don't see them on the map. I would not like to share data with known companies but to receive only for me. Is it possible to do this? Or is it necessary for MLAT to install an image of these companies? Thank you all Maurizio
MLAT requires a server to coordinate multiple receivers and do calculations. You can install our feed scripts and MLAT should work if there are enough other receivers that receive the same aircraft. https://github.com/adsbxchange/adsb-exchange/#obtaining-and-using-the-scripts Without sharing your data with us or one of the other feed networks, MLAT isn't possible.
Very well and thank you. I try to install tonight. But can I put the rings with the miles from my position? Regards Maurizio
https://github.com/wiedehopf/adsb-scripts/wiki/Automatic-installation-for-dump1090-fa Install this and configure location as described on that page.
It should be enabled via the gears. Try my interface, it adds onto the existing dump1090-fa or readsb: https://github.com/wiedehopf/tar1090#tar1090 Other interface will still be available.
I tried but nothing. Home reset I go to New York if i use adsb Scope does it work? Regards Ok Done. It works with the Tar1090 Regards
