Hi, I want to use my microADSB instead of the RTL-SDR at the Raspberry. I think I need to change that one: /boot/adsbx-env # Default no serial single SDR mode # use # to comment out for 1090 mode RECEIVER_OPTIONS="--device-type rtlsdr --ppm 0" I also found this: Step 4.1 - Receiver selection: 1 - DVBT Stick (USB) ----------------------------------------------------- 2 - SBS1/SBS1er (USB/Network) 3 - SBS3 (USB/Network) 4 - ModeS Beast (USB/Network) 5 - AVR Compatible (DVBT over network, etc) 6 - microADSB (USB/Network) 7 - SBSx via Basestation (localhost:30006) ...therefore receiver 6 Receiverdetail: usb-sprut__www.sprut.de__ADSB-PIC_V.10__sprut_2012_-if00 -> ../../ttyACM0 But how to configure that at RECEIVER_OPTIONS? How to setup the com port?
OK thanks. FYI - 3 reasons for my request. 1) want to use my rtl-sdr differently 2) my rtl-sdr is getting quite warm (concerned about power consumption) 3) I expected that the microADSB receiver is better because of it's design for ADS-B (filter, bandwith,..)
Yeah i do understand the request but i can't help you. The microADSB receiver doesn't give timestamps and just has very bad reception. No timestamps means no MLAT. We simply don't want to support it sorry!
No problem!! It's a really great software. No need to include microADSB. I simply need to buy another rtl-sdr.
