Hi folks, On the custom image page https://www.adsbexchange.com/how-to-feed/adsbx-custom-pi-image/ steps 3 and 4 mention connecting to your Wifi. My Pi won't be a position reach the Wifi signal so I was going to use an RJ45 cable connection to my router. Will this work? Also, in step 4 is says to visit http://adsbexchange.local - This link doesn't go anywhere, is there an alternative or an updated page please? Thanks in advance. Joe
The wifi hotspot is active for 15 mins. Just plug in an ethernet cable and point a browser at the IP address of the Pi. The dot local is just a simpler way to use the config pages, without having to find the actual IP address. Check your router. You should see the IP address of the Pi in the client list.
Hi yes thanks Kuunanet. The whole setup was a lot easier than I had anticipated. Thanks for your help.
