readsb show aircrafts but they don't appear on tar1090

Discussion in 'Feeding' started by samtc, Nov 2, 2020.

  1. samtc

    samtc New Member

    Hi,

    I'm running adsbx-1.0.6 but no aircrafts appear on the web map (tar1090).

    When I ssh on my adsbx feeder and run:

    readsb --interactive

    I see aircrafts. Any idea why they don't show up on the map?

    Thanks,

    Sam
     
    samtc, Nov 2, 2020
    #1
  2. wiedehopf

    wiedehopf Administrator Staff Member

    If you run readsb like that and it works that means the service that should be running isn't running.

    Bad configuration most likely, either post your configuration here or send it to me on discord.
     
    wiedehopf, Nov 2, 2020
    #2
  3. samtc

    samtc New Member

    The PI was underpowered: I was using a 700mA power supply, I now use a 2000mA power supply and it works.

    In syslog I had lots of "No data received from the SDR for a long time, it may have wedged".

    Thanks!
     
    samtc, Nov 3, 2020
    #3
  4. Aaron Holland

    Aaron Holland New Member

    That is still way to low you need at least 2.5 amps
     
    Aaron Holland, Nov 4, 2020
    #4